Precision Bipolar Isolation Card
Model D10562-000

General DescriptionStandard FeaturesSpecificationsApplication ExampleDimensions/Connections


Specifications

A.C. INPUT

  • 115VAC ±10%, 50/60 Hz, internally fused at .3 Amps

ISOLATION VOLTAGE

  • 2400V peak at 1 second or 1500VRMS

LINEARITY

  • ±0.1% of 10VDC span

SIGNAL INPUTS

  • Potentiometer input
    ±5VDC available to source a 500 to 10,000 Ohm potentiometer. The 10VDC range should be selected for this type of input.
  • Voltage input
    7 selectable ranges with 100K to 10M Ohm input impedance.
  • Input range Input impedance
    -100mVDC to +100mVDC 100K
    -1VDC to +1VDC 1M
    -2.5VDC to +2.5VDC 100K
    -10VDC to +10VDC 10M
    -25VDC to +25VDC 1M
    -100VDC to +100VDC 10M
    -250VDC to +250VDC 10M
  • Load cell input
    4 selectable multiplier ranges with 10G Ohm input impedance. ±5VDC available for excitation voltage capable of sourcing 75mA.
 
  • Trim potentiometer input
    Allows connection of an external 10,000 Ohm potentiometer to trim the output. The trim range may be as wide as 0 to 100% or limited to 80 to 100%.
  • Auxiliary input
    This allows a fixed or variable signal (-10VDC to +10VDC) to be summed directly with the scaled input signal. The polarity may be inverted by selecting (-) on J6. Isolation is maintained between the auxiliary input and the output.
  • Summing input
    This input allows a fixed or variable signal (-10VDC to +10VDC) to be summed directly (gain of 1) with the output. The polarity may be inverted by selecting (-) on J7. Isolation is not maintained between the summing input and the output.

OUTPUT TYPES

  • Voltage output
    Selected by position V on jumper J8. This circuit allows the output the source a ±10VDC voltage level into a minimum resistance of 500 Ohms. If the resistance is too low, output linearity may be affected.
  • Current output
    Selected by position I on jumper J8. This circuit allows the output to source a regulated current of up to 20mAmps into a maximum resistance of 500 Ohms. Using the BIAS potentiometer, the output can source a 4 to 20mAmp signal.

 

VIEW INSTRUCTION MANUAL
View Brochure


General DescriptionStandard FeaturesSpecificationsApplication ExampleDimensions/Connections

Back to System Interface ComponentsBack to Product Line

Precision Bipolar Isolation Card
Model D10562-000

Stay in touch with us

Have any questions?
Contact Us