Dancer Position Card (PID Regulator)
Model D10541

• 115 VAC ±10%, 50/60 Hz., Internally fused at 0.3 amps

Isolation Voltage

• 2400 V PEAK at 1 second or 1500 VRMS max.
• NOTE: The scaling input is the only input that is isolated from the output.

Scaling Input

Position Potentiometer Input

• -15 VDC available to supply a 2K to 10K ohm potentiometer

Dancer Potentiometer Input

• +15 VDC available to supply a 2K to l0K ohm potentiometer

• Fixed or variable -10 VDC to +10 VDC with a selection to change the function, addition or subtraction as required. Isolation is not maintained between this input and the output.

External Reset Input

• Contact closure required to reset internal control circuits.
  
• Note: This contact should be closed any time the dancer drive is disabled.
  

MIN. and MAX. Count Output

• Minimum and maximum count on the digital to analog converter are each indicated by a normally open contact rated at 120VAC at 1 amp.
  

Voltage Output

• Bipolar: This circuit allows the output to source up to ±10VDC into a min. resistance of 1K ohms.
  
• Positive: This circuit allows the output to source up to +10VDC into a min. resistance of 1K ohms.
  
• Negative: This circuit allows the output to source up to -10VDC into a min. resistance of 1K ohms.