>> Sensorless Flux Vector Control Flux Vector Compensation with Static Auto-Tune provides excellent speed regulation with high torque loads throughout the entire speed range. Auto energy saving at light loads. Smooth motor torque.
>> Electronic Inrush Current Limit (EICL™) Protection Eliminates harmful inrush AC line current during power up.
>> Run/Fault Relay Output Contacts Can be used to turn equipment on or off, to signal a warning if the drive is put into“Stop” mode, or to signal if a fault has occurred.
>> Start/Stop Switch Provides electronic “Start” and “Stop” functions.
>> Ride-Through Provides smooth recovery to the previous set speed during a momentary power loss.
>> Holding Torque at Zero Speed Resists motor shaft rotation when the drive is in “Stop” mode.
>> Regeneration Protection Eliminates tripping due to high bus voltage caused by rapid deceleration of high inertial loads.
>> Undervoltage and Overvoltage Protection Shuts down the drive if the AC line input voltage goes above or below the operating range.
>> Short Circuit Protection Shuts down the drive if a short circuit occurs at the motor (phase-to-phase).
>> Basic, Programmable, Trimpot Adjustments Min. Speed, Max. Speed, Accel, Decel, Current Limit, Slip Comp.
>> GFCI software Allows equipment to operate with Ground Fault Circuit Interruption circuit breakers or outlets. *With factory programming.
>> On/Off AC Line Switch Disconnects the AC line.
>> Forward-Stop-Reverse Switch Provides motor reversing and stop functions.
>> Signal Isolator Provides isolation between a non-isolated signal source and the drive.
>> Auto/Manual Switch When used with the Signal Isolator, it selects the remote process signal or the Main Speed Potentiometer.
>> Class “A” (CE) RFI Filter Installs inside the drive.
>> Liquidtight Fittings Provides a liquid-tight seal for wiring the drive. Kit includes necessary liquid-tight fittings.