A.C. INPUT
115 VAC 50/60 Hz, internally fused at 0.3 AMPS

ISOLATION VOLTAGE
2400V peak at 1 second or 1500 VRMS

LINEARITY
±0.5% of 10 VDC span

SIGNAL INPUTS
Potentiometer Input (Input A & B) +15 VDC available to source a 2K to 10K Ohm potentiometer.
The 10 VDC input range should be selected for this
type of input.
Voltage Input (Input A & B)
7 selectable ranges with 100K to Ohm input impedance.

Note: Negative input voltages cannot be used at
Input A when the D11005-000 is used in the Divide Mode of Operation. input types

Auxiliary Input A
This allows a fixed or variable signal (-10 VDC to +10 VDC) to be summed directly with the scaled input signal at Input A. Isolation is maintained from the Auxiliary Input A to Input B signals and the Output.

Auxiliary Input B
This allows a fixed or variable signal (-10 VDC to +10 VDC) to be summed directly with the scaled input signal at Input B. Isolation is maintained from the Auxiliary Input B to Input A signals and the Output.

Summing Input
This input allows a fixed or variable signal (-10 VDC to +10 VDC) to be summed directly with the output. Isolation is not maintained between the summing input and the output.

OUTPUT TYPES
Voltage Output
This circuit allows the output to source a voltage level into a minimum resistance of 500 OHMS. (Lower load resistance may affect output linearity.)
Current Output
This circuit allows the output to source a regulated current of up to 20mA into a maximum resistance of 500 OHMS. Using the BIAS Potentiometer, the output can source a 4-20mA signal.
Meter Output
This output can be used to source a voltage level to a meter with a minimum 2K internal resistance. Its range can be set by the METER RANGE Potentiometer.